[Gmsh] cgns: Segmentation fault

[David Colignon]

Hi Dragan,

sorry, I am not able to see any peculiar detail in your screenshot...

But can you try to add the option "-optimize" on the command line to improve the quality of the mesh ?

Regards,

Dave

--
David Colignon, Ph.D.
Collaborateur Logistique du F.R.S.-FNRS
CÉCI - Consortium des Équipements de Calcul Intensif
ACE - Applied & Computational Electromagnetics
Institut Montefiore B28
Université de Liège
4000 Liège - BELGIQUE
Tél: +32 (0)4 366 37 32
Fax: +32 (0)4 366 29 10
WWW:    http://hpc.montefiore.ulg.ac.be/
Agenda: http://www.google.com/calendar/embed?src=david.colignon%40gmail.com

On 14/05/10 14:58, Dragan Vidovic wrote:
> Hi
>
> By meshing a simple unit cube using
>
> gmsh -3 -clmax 0.05 unitcubeUns.geo
>
> I obtained a mesh with a peculiar detail that you can see in the
> attached screenshot. It seems like gmsh was slicing one single
> tetrahedron. This causes certain death to my FV code. Is there any way
> to make sure that this does not happen?
>
> Regards,
>
> Dragan
>
>
>
> _______________________________________________
> gmsh mailing list
> gmsh at geuz.org
> http://www.geuz.org/mailman/listinfo/gmsh