[Gmsh] cgns: Segmentation fault

Mikhail Titov mlt at gmx.us
Fri May 14 18:18:22 CEST 2010


Dragan:

Could you attach your geo file? It looks like the node numbering is
wrong. Could you double check that all cube nodes are in correct order
in your geo file? Though I'm not confident about it.

--
Mikhail

On 05/14/2010 07:58 AM, Dragan Vidovic wrote:
> Hi
>
> By meshing a simple unit cube using
>
> gmsh -3 -clmax 0.05 unitcubeUns.geo
>
> I obtained a mesh with a peculiar detail that you can see in the
> attached screenshot. It seems like gmsh was slicing one single
> tetrahedron. This causes certain death to my FV code. Is there any way
> to make sure that this does not happen?
>
> Regards,
>
> Dragan
>   
>
>
> _______________________________________________
> gmsh mailing list
> gmsh at geuz.org
> http://www.geuz.org/mailman/listinfo/gmsh
>