[Gmsh] single layer extrusion

[Christophe Geuzaine]

> On 28 May 2018, at 18:36, andrew <armitatz at gmail.com> wrote:
> 
> 
> Hi,
> 
> I am trying to make a 3d mesh from an extruded 2d mesh. I use the code attached but when I run the code I get 2 layers instead of one. Is there a way to get a single extruded layer or I am doing something wrong?
> 

This is due to the fact that you set "Mesh.SubdivisionAlgorithm".

(Note that in 3D you should set "Mesh.SubdivisionAlgorithm = 2" to get a conformal mesh.)


> Kind regards
> 
> Andrew
> 
> <Clipboard02.jpg><test.geo>_______________________________________________
> gmsh mailing list
> gmsh at onelab.info
> http://onelab.info/mailman/listinfo/gmsh

— 
Prof. Christophe Geuzaine
University of Liege, Electrical Engineering and Computer Science 
http://www.montefiore.ulg.ac.be/~geuzaine

Free software: http://gmsh.info | http://getdp.info | http://onelab.info

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://onelab.info/pipermail/gmsh/attachments/20180530/d0ae374c/attachment.html>