[Gmsh] Please help (Error while meshing a geometry)

[David Colignon]

Hi,

I have never had this kind of error about "JIT" , but there are some problems with your geometry:

-- point 1 lies in the middle of line 4. this line going from point 2 to 12 should be split in two lines, one from 2 to 
1, and the other from 1 to 12

-- surface 23 is overlapping the four surfaces 40, 58 , 68 , 78 , and this is why the 3d meshing algo crashes.


Regards,

Dave

-- 
David Colignon, Ph.D.
Collaborateur Logistique du F.R.S.-FNRS
CÉCI - Consortium des Équipements de Calcul Intensif
ACE - Applied & Computational Electromagnetics
Sart-Tilman B28
Université de Liège
4000 Liège - BELGIQUE
Tél: +32 (0)4 366 37 32
Fax: +32 (0)4 366 29 10
WWW:    http://hpc.montefiore.ulg.ac.be/
Agenda: http://www.google.com/calendar/embed?src=david.colignon%40gmail.com


On 11/06/10 06:07, Sharobeam, Monir wrote:
> I am a new gmsh user and the attached small geo file includes a
> preliminary geometry of an artificial hip. When I tried to do a 3D mesh,
> I got an error that JIT must be enabled. What is JIT? and how can it be
> enabled?
> Thanks.
> Monir Sharobeam
> Professor
> The Richard Stockton College of New Jersey
>
>
>
> _______________________________________________
> gmsh mailing list
> gmsh at geuz.org
> http://www.geuz.org/mailman/listinfo/gmsh