[Gmsh] Boundary layers in gmsh?

[julien hoessler]

Hi Eric,
If it is a flat surface or if you know where the interface would be  
located you can just move your domain line/surface to the interface  
and extrude it towards the outside, but otherwise I can't seem to find  
a way to link the interface with the rest of the mesh
regards
Julien
On 24 Feb 2010, at 02:03, Eric Nutsch wrote:

> Hi,
>
>
> Has anyone successfully gotten an extruded boundary layer to interface
> with a mesh?
>
>
> Thanks,
> Eric Nutsch
>
> _______________________________________________
> gmsh mailing list
> gmsh at geuz.org
> http://www.geuz.org/mailman/listinfo/gmsh

Julien Hoessler
PhD Student
Department of Aeronautics
Imperial College London

Phone: +44 (0) 20759 45042
Email:   julien.hoessler06 at imperial.ac.uk