[Gmsh] Mesh doesn't show when I change Geometry.OCCTargetUnit from "M" to "MM";

[Marco Antolovic]

 Just fixed it by selecting "Restore all Options to Default Setting" in the Help menu and then setting again
Geometry.OCCTargetUnit = "MM"

Unfortunately because of the general option reset I can't tell which option created the problem but at least now the problem is solved.
Marco
 

    Il martedì 17 novembre 2020, 10:01:47 CET, Christophe Geuzaine <cgeuzaine at uliege.be> ha scritto:  
 
 

> On 13 Nov 2020, at 19:37, Marco Antolovic <marco_antolovic at yahoo.it> wrote:
> 
> Hi all,
> 
> I'm trying to mesh the attached step file and I'm experiencing a strange Gmsh behavior when I change Geometry.OCCTargetUnit = "M" to Geometry.OCCTargetUnit = "MM"
> 
> Keeping all other options unchanged, when I use "M" the domain is meshed and I can see the mesh but I when I switch to "MM" although meshing process is shown (and completed succesfully with 22153 nodes 112879 elements) in the message console the mesh is nowhere to be seen. 
> 

Did you figure it out? I cannot reproduce the issue.

Christophe


> The min/max element size should not be a problem (for me it is set to 0/2). 
> 
> My Gmsh Version is 4.7.0-git-0dc1450
> 
> Any help is much appreciated.
> 
> Thanks,
> 
> Marco
> 
> <4_layers_V02.step>_______________________________________________
> gmsh mailing list
> gmsh at onelab.info
> http://onelab.info/mailman/listinfo/gmsh

— 
Prof. Christophe Geuzaine
University of Liege, Electrical Engineering and Computer Science 
http://people.montefiore.ulg.ac.be/geuzaine



  
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://onelab.info/pipermail/gmsh/attachments/20201117/5e32bc17/attachment.html>