[Gmsh] Problem with boundary layer.

[Jie Chen]

Dear All,

I have a very simplified model, just a cylinder with a small pump on
the side.  My objective is to add some boundary layer on the wall.
However, when I check the mesh using clipping planes, I found no
boundary layer whatever the parameters I set for the boundary layer.

Any suggestions?

Thanks,

Jie
-------------- next part --------------
A non-text attachment was scrubbed...
Name: model.brep
Type: application/octet-stream
Size: 38407 bytes
Desc: not available
URL: <http://www.geuz.org/pipermail/gmsh/attachments/20120424/48a401e5/attachment.brep>
-------------- next part --------------
A non-text attachment was scrubbed...
Name: boundarytest.geo
Type: application/octet-stream
Size: 512 bytes
Desc: not available
URL: <http://www.geuz.org/pipermail/gmsh/attachments/20120424/48a401e5/attachment.geo>