[Gmsh] Trouble meshing one volume

[David Colignon]

Hi,

it is very strange. If you define only volume 849 ( movingpole1_849.geo attached ) , the volume is meshed...

The good news is that you use the frontal 3D meshing algo (Tools->Options->Mesh->General->3D algorithm->Frontal), 
everything works fine !

Regards,

Dave


-- 
David Colignon, Ph.D.
Collaborateur Logistique du F.R.S.-FNRS
CÉCI - Consortium des Équipements de Calcul Intensif
ACE - Applied & Computational Electromagnetics
Sart-Tilman B28
Université de Liège
4000 Liège - BELGIQUE
Tél: +32 (0)4 366 37 32
Fax: +32 (0)4 366 29 10
WWW:    http://www.ceci-hpc.be/
Agenda: http://www.google.com/calendar/embed?src=david.colignon%40gmail.com


On 12/07/11 14:56, Robin Cornelius wrote:
>
> Hi,
>
> Hope someone can help with this.. I'm having trouble meshing the attached model. One of the volume regions is failing to
> volume mesh without any obvious errors on the console. Its volume 849 in the attached geo. Hopefully someone can point
> out what error i have made as I can't for the life of me find it.
>
> Also one final question is there some way to easily create what i refer to as an "air box" that is if I define a model
> then an outer boundary I usually then have to create an air volume and set all the surfaces of the actual model as part
> of the hole of that air volume. Is it possible to create an outer airbox then just specify the inner volumes to exclude
> as a hole rather than having to set all the inner surfaces as holes which can get quite difficult and be very error prone.
>
> Thanks in advance
>
>
>
> _______________________________________________
> gmsh mailing list
> gmsh at geuz.org
> http://www.geuz.org/mailman/listinfo/gmsh
-------------- next part --------------
An embedded and charset-unspecified text was scrubbed...
Name: movingpole1_849.geo
URL: <http://www.geuz.org/pipermail/gmsh/attachments/20110712/20e7c81a/attachment.geo>