[Gmsh] Post-processing: Assigning a single view to display scalar andvector data.
mark.starnes at fttech.co.uk
Wed Mar 31 17:52:33 CEST 2010
I have data I would like to display with gmsh, consisting of pressure (a
scalar) and structural displacement (a vector). Currently, I'm
displaying the pressure and displacement as separate views and merging
them together by pressing the two post-processing view buttons. This is
`clunky' though and a pain to perform when there are many different
frequency results to run though.
I'm wondering if it's possible to lump the displacements (real and
imaginary and three components) and the pressures (real and imaginary
but one component) into a single view. Experiments so far are failing
Any suggestions would be appreciated!
FT Technologies Limited is registered in England and Wales under registered number 01603909. Its registered office is at Church Lane, Teddington, Middlesex, TW11 8PA.
The information in this message is confidential and is intended only for the use of the intended recipient(s). If you are not an intended recipient, you should not disclose, use or copy this information. Please contact the sender immediately if you have received this message in error.
More information about the gmsh