[Gmsh] mesh a point inside a surface

[David Colignon]

Hi Jean-Pierre,

you should use the following command:

Point {1, 7, 23} In Surface {47} ;

http://www.geuz.org/gmsh/doc/texinfo/gmsh.html#Miscellaneous-mesh-commands

Regards,

Dave


-- 
David Colignon, Ph.D.
Collaborateur Logistique du F.R.S.-FNRS
CÉCI - Consortium des Équipements de Calcul Intensif
ACE - Applied & Computational Electromagnetics
Sart-Tilman B28
Université de Liège
4000 Liège - BELGIQUE
Tél: +32 (0)4 366 37 32
Fax: +32 (0)4 366 29 10
WWW:    http://hpc.montefiore.ulg.ac.be/
Agenda: http://www.google.com/calendar/embed?src=david.colignon%40gmail.com


On 12/03/10 09:38, jean pierre aubry wrote:
> hello
>
> here is the problem :
> i have a Plane Surface defined by a Line Loop
> on this surface (in the same plane) i have one or several Points
> is there a way to force these Points to become Nodes once the Surface is
> meshed
> for example i want to apply boundary conditions on these Points
> of course i could (ana i presently do) divide into several Surfaces
> sharing these Points as vertex
>
> there may be a more clever way to do
> if anyone knows?
> thanls
>
> jean perre aubry
>
>
> _______________________________________________
> gmsh mailing list
> gmsh at geuz.org
> http://www.geuz.org/mailman/listinfo/gmsh