[Gmsh] Meshing error

[David Colignon]

Hi,

with the "Coherence;" command, when two points are merged, that can create a zero-lenght line and the 2nd order meshing 
fails.
We added a test that prints an error when zero-length lines are encountered. Can you try the latest nightly build ?


Regards,

Dave



-- 
David Colignon, Ph.D.
Collaborateur Logistique du F.R.S.-FNRS
CÉCI - Consortium des Équipements de Calcul Intensif
ACE - Applied & Computational Electromagnetics
Sart-Tilman B28
Université de Liège
4000 Liège - BELGIQUE
Tél: +32 (0)4 366 37 32
Fax: +32 (0)4 366 29 10
WWW:    http://hpc.montefiore.ulg.ac.be/
Agenda: http://www.google.com/calendar/embed?src=david.colignon%40gmail.com


On 01/02/10 11:50, 정상엽 wrote:
> Dear gmsh developer
>
> When i meshing the geometry that is contained in this mail,
>
> In GUI, it suddenly stop and distinguish,
>
> And in Non-GUI mode, i wrote down as follows:
>
>  >> gmsh per_voron.geo -3 -algo del3d -order 2 -clscale 1.0 -o
> per_voron.msh
>
> then it stops at 2D meshing step.
>
> When I check the geometry, there is no error or fault.
>
> Can you tell me why I cannot meshing this geometry??
>
>
> Regards,
>
> Chung
>
>
>
>
> _______________________________________________
> gmsh mailing list
> gmsh at geuz.org
> http://www.geuz.org/mailman/listinfo/gmsh