[Gmsh] Copy

Ruth V. Sabariego r.sabariego at ulg.ac.be
Wed Jun 10 16:59:02 CEST 2009


For copying not just the geometry but also the properties of your mesh, 
you must add to your file:
Geometry.CopyMeshingMethod=1;

Regards,
Ruth


dolfyn wrote:
> Dear all,
>
> Suppose one has a 'blocking' (nodes, lines, transfinite lines and 
> (recombined) plane surfaces)... something like:
>
>   +-----+----+
>   |     |    |
> ..+-----+----+.... (x axis)
>
> (it's a bit more complex) when this is meshed (2D) one gets a nice 
> quad mesh. Now I would like to save time and effort and copy/mirror 
> this, say, using the x-axis.
>
> If one hits 2D meshing then the new 'blocking' has obviously lost 
> the transfinite/recombined settings.
>
> Does anybody has examples of the 'Dilate' (and 'Duplicata' 
> commands)? Geometrical entities are copied but not the attributes.
>
> Next step was to extrude the model; the positive y-part and then 
> copy/mirror the 3D (hexahedral) mesh and hopefully also 
> the 'physical volumes and surfaces'.
>
> Is this possible?
>
> Thanks in advance!
>
> Henk
>
>
>
>
>
>
> _______________________________________________
> gmsh mailing list
> gmsh at geuz.org
> http://www.geuz.org/mailman/listinfo/gmsh
>   


-- 
Dr. Ir. Ruth V. Sabariego
University of Liege, Institut Montefiore,
Dept. of Electrical Engineering & Computer Science, 
Applied & Computational Electromagnetics (ACE),
Sart Tilman Campus, Grande Traverse, 10 (B28), B-4000 LIEGE, Belgium
phone: +32-4-3663737 -- fax: +32-4-3662910 -- http://elap.montefiore.ulg.ac.be/