[Gmsh] Meshing STL File

[Antoine Dechaume]

I have a similar behaviour, but with a standard geo script, no stl.

I have some a relatively small characteristic length, for some value  
it crashes, but not if this value is slightly modified (bigger or  
smaller), though the surface mesh is ok, the mesh inside it is not  
relevant (just as meshed with much bigger characteristic length).

This happens with version 2.2.1 but not with 2.2.0.

Antoine


On 17-Jun-08, at 8:12 PM, jbi35 at student.canterbury.ac.nz wrote:

>
> Hi there,
>
> i am currently using gmsh to create 3d volume meshes from an stl  
> file, which describes the surface. In order to create meshes with  
> different mesh sizes i can create finer or coarser surface  
> meshes( stl's) The problem is that gmsh does not work for some mesh  
> sizes
> e.g it works for 0.002 and 0.0022 but not for 0.0019 or 0.0021.
> Has anybody had similar problems in the past ? Or knows a remedy??
>
> thanks for your help
>
> cheers jonas
>
>
>
>
>
> _______________________________________________
> gmsh mailing list
> gmsh at geuz.org
> http://www.geuz.org/mailman/listinfo/gmsh