[Gmsh] no tets in mesh saved as STL

Ernest Johnson ejohnson.lpool at yahoo.com
Mon May 5 13:57:38 CEST 2008


>Hi Ernest - To avoid writing format translators again and again (IIRC 

>several people on this list are also interested in the VTK format), it 
>would actually be really nice if you could directly add a routine in 
>Gmsh to save a mesh in VTK format.

I'm not sure if I know enough to write a valid VTK file.  The code that I produce would probably work fine for my purposes, but cause other applications to fail. If some open source converter (or any other project that writes a general, unstructured mesh) to the VTK format exists, I offer to integrate that code into gmsh. Any suggestions where to start?

Best,
Ernest



      ____________________________________________________________________________________
Be a better friend, newshound, and 
know-it-all with Yahoo! Mobile.  Try it now.  http://mobile.yahoo.com/;_ylt=Ahu06i62sR8HDtDypao8Wcj9tAcJ
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://www.geuz.org/pipermail/gmsh/attachments/20080505/8b7d288f/attachment.html>