[Gmsh] Fwd: Re: Extract/highlight geometry edges
billy at dem.uminho.pt
billy at dem.uminho.pt
Thu Mar 23 21:58:41 CET 2006
----- Forwarded message from billy at dem.uminho.pt -----
Date: Sun, 19 Mar 2006 01:14:45 +0000
From: billy at dem.uminho.pt
Reply-To: billy at dem.uminho.pt
Subject: Re: [Gmsh] Extract/highlight geometry edges
To: Christophe Geuzaine <cag32 at case.edu>
Hi,
I did that but it translated the stl. Is this a bug?
Billy.
Quoting Christophe Geuzaine <cag32 at case.edu>:
> billy at dem.uminho.pt wrote:
> > Hello,
> >
> > Is there a way to extract edges from a mesh? This because I want to include
> the
> > edges of the geometry in the post-processing view but the lines used to
> > construct the geometry look too confusing (to build the geometry I need
> more
> > lines than just the edges).
> >
>
> You could save the surface mesh as an STL file (File->Save as->STL) and
> reload it: this will detect the edges. (You can change the STL options
> and use 'Update edges' in the mesh menu to refine the angle threshold.)
>
>
> > Billy.
> > _______________________________________________
> > gmsh mailing list
> > gmsh at geuz.org
> > http://www.geuz.org/mailman/listinfo/gmsh
> >
>
>
> --
> Christophe Geuzaine
> Assistant Professor, Case Western Reserve University, Mathematics
> http://www.case.edu/artsci/math/geuzaine
>
----- End forwarded message -----