[Gmsh] Problem with geometry modeling

[Christophe Geuzaine]

> On 5 Jul 2019, at 15:17, Alessandro Vicini <alessandro.vicini at sitael.com> wrote:
> 
>  
> Sorry if in these days I’m spamming a bit… J
>  
> I attach a geo file (Test_04, together with spline.geo which is merged into it). I need to generate the plane surface which is shown in the attached picture, but gmsh doesn’t accept the inner circle as a hole…. Any suggestions…? Thank you.
>  

Hi Alessandro,

I don't get the same geometry as yours when I open your file with Gmsh 4.4. Can you check?

Christophe


> Alessandro
>  
> <Test_04.geo><spline.geo><surface.jpg>_______________________________________________
> gmsh mailing list
> gmsh at onelab.info
> http://onelab.info/mailman/listinfo/gmsh

— 
Prof. Christophe Geuzaine
University of Liege, Electrical Engineering and Computer Science 
http://www.montefiore.ulg.ac.be/~geuzaine