[Gmsh] writing support points in mesh file

[David Colignon]

Hi,

See  http://gmsh.info/doc/texinfo/gmsh.html#Elementary-vs-physical-entities

Regards,

Dave

-- 
David Colignon, Ph.D.
1er logisticien de recherche
Université de Liège
ACE - Applied & Computational Electromagnetics
Sart-Tilman B28
10, Grande Traverse
4000 Liège - BELGIQUE
Tél: +32 (0)4 366 37 32
http://www.ulg.ac.be/nic4


On 01/04/17 15:09, nijso beishuizen wrote:

> Dear all,
> 
> If you create a circle, you need a support point, the middle of the
> circle. If I write a mesh file (e.g. in SU2 format), the support point
> is included in the list of points. This then gives problems with SU2
> because there are more actual nodes than used nodes.
> 
> So: I would like to delete all points that are not used in the actual
> mesh.
> 
> Is there a way to force gmsh to skip the writing of points that are not
> used in the mesh?
> 
> 
> Best regards,
> Nijso Beishuizen
> 
> 
> _______________________________________________
> gmsh mailing list
> gmsh at onelab.info
> http://onelab.info/mailman/listinfo/gmsh
>