[Gmsh] Problem with "Periodic Surface" defined using splines.

[Uģis Lācis]

ear Gmsh developers and users,

I have been routinely using the very nice feature of Gmsh that allows to 
define periodic surfaces and exactly the same meshes at opposite sides 
of the domain.

However, trying to define the geometry with splines, I have stumbled on 
a weird problem. The Gmsh software spits out error about not finding 
periodic counterpart of edge, while meshing in 1D does not complain 
about anything (see attached example.log). The corresponding GEO file is 
also attached. I am meshing the domain using command line call
gmsh -3 example.geo
I use version 2.16.0, I have checked that 2.12 produces the same 
outcome. After the error message, the Gmsh crashes with segmentation 
fault for me.

I have tried removing the Periodic definition for the problematic 
surface and then everything works absolutely fine.

Do you have any suggestions or could you point me in any direction, 
which could solve this problem?

Best Regards,
Ugis Lacis
-------------- next part --------------
A non-text attachment was scrubbed...
Name: example.geo
Type: application/vnd.dynageo
Size: 4097 bytes
Desc: not available
URL: <http://onelab.info/pipermail/gmsh/attachments/20170221/bc3f41b8/attachment.geo>
-------------- next part --------------
A non-text attachment was scrubbed...
Name: example.log
Type: text/x-log
Size: 3955 bytes
Desc: not available
URL: <http://onelab.info/pipermail/gmsh/attachments/20170221/bc3f41b8/attachment.log>