[Gmsh] error message "a tet is not connected by a boundary face"

[Massimiliano Martinelli]

Thank you very much!

MM

On 02/09/17 22:30, Fabrice Pepin wrote:
> Hello,
>
> I got the same error but changing the 3D mesh algorithm with frontal
> solved the issue. I suggest you read the mesh section in the
> documentation as valuable infos are given.
>
> Regards,
> Fabrice.
>
>
> ------------------------------------------------------------------------
> *De :* Massimiliano Martinelli <martinelli at imati.cnr.it>
> *À :* gmsh at onelab.info
> *Envoyé le :* Jeudi 9 février 2017 12h03
> *Objet :* [Gmsh] error message "a tet is not connected by a boundary face"
>
>
> Good morning,
>
> I have a problem using GMsh.
>
> I would like to generate a 3D mesh for the simple gemoetry defined by
> the attached script.
> The 1D and 2D mesh generation are ok but running the 3D mesh generation
> I obtain the following messages:
> "a tet is not connected by a boundary face".
>
> Am I doing something wrong?
>
> PS: I'm using GMsh 2.16 with GUI on MacOSX and I have not changed the
> default settings.
>
> Thank you very much,
> Massimiliano Martinelli
>
>
> -- 
> Massimiliano Martinelli
> IMATI "E.Magenes" - CNR
> via Ferrata 5, 27100 Pavia
> (+39) 0382 548234
>
> _______________________________________________
> gmsh mailing list
> gmsh at onelab.info <mailto:gmsh at onelab.info>
> http://onelab.info/mailman/listinfo/gmsh
>
>


-- 
Massimiliano Martinelli, PhD.
IMATI-CNR "E.Magenes" Pavia
martinelli at imati.cnr.it
+39 0382 548234

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://onelab.info/pipermail/gmsh/attachments/20170210/33eb430c/attachment.html>