[Gmsh] Cylindrical Patches as Surface

[Vollmer Uwe (CR/ARE3)]

Good Morning,

is it possible to have the same appendix for a cylindrical surface patch similar to the spherical one as described below.

Ruled Surface ( expression ) = { expression-list } < In Sphere { expression } >;
Creates a ruled surface, i.e., a surface that can be interpolated using transfinite interpolation. The expression inside the parentheses is the ruled surface's identification number; the first expression-list on the right hand side should contain the identification number of a line loop composed of either three or four elementary lines. The optional In Sphere argument forces the surface to be a spherical patch (the extra parameter gives the identification number of the center of the sphere).


Mit freundlichen Grüßen / Best regards

Dr. Uwe Vollmer

Applied Research 2 - Electrodynamics and Drives - Drives Technology, Power Electronics (CR/ARE3)
Robert Bosch GmbH | Renningen | 70465 Stuttgart | GERMANY | www.bosch.com<http://www.bosch.com>
Tel. +49(711)811-24976 | Fax +49(711)811 | Uwe.Vollmer at de.bosch.com<mailto:Uwe.Vollmer at de.bosch.com>

Sitz: Stuttgart, Registergericht: Amtsgericht Stuttgart, HRB 14000;
Aufsichtsratsvorsitzender: Franz Fehrenbach; Geschäftsführung: Dr. Volkmar Denner,
Dr. Stefan Asenkerschbaumer, Dr. Rolf Bulander, Dr. Stefan Hartung, Dr. Markus Heyn, Dr. Dirk Hoheisel,
Christoph Kübel, Uwe Raschke, Dr. Werner Struth, Peter Tyroller


-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://onelab.info/pipermail/gmsh/attachments/20160830/644c3e31/attachment.html>