[Gmsh] 3D Cylinders in GMSH

[Aristodemou, Elsa]

Dear GMSH team, hi!

I am trying to create a 3D mesh for a Culinder/pipe, within a larger 3D domain - for my students,
as in my attached geometry.

Everything seems to look OK....but it's obvious that it is not meshing properly....

Would you advice me please as to how to solve the problem? Or perhaps suggest an alternative solution/geo file that will do the same, so that i can show it to my students?

Thanks ever so much for your help.

Elsa Aristodemou (Dr.)
London South Bank University, UK.
Copyright in this email and in any attachments belongs to London South Bank University. This email, and its attachments if any, may be confidential or legally privileged and is intended to be seen only by the person to whom it is addressed. If you are not the intended recipient, please note the following: (1) You should take immediate action to notify the sender and delete the original email and all copies from your computer systems; (2) You should not read copy or use the contents of the email nor disclose it or its existence to anyone else. The views expressed herein are those of the author(s) and should not be taken as those of London South Bank University, unless this is specifically stated. London South Bank University is a company limited by guarantee registered in England and Wales. The following details apply to London South Bank University: Company number - 00986761; Registered office and trading address - 103 Borough Road London SE1 0AA; VAT number - 778 1116 17 Email address - LSBUinfo at lsbu.ac.uk
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://www.geuz.org/pipermail/gmsh/attachments/20150830/e78e2992/attachment-0001.html>