[Gmsh] STL remesh problem

[Christophe Geuzaine]

Hi Mario,

Here's your example, slightly changed to make this happen. (To make it nicer you should probably group some of the smaller bits on one side).

Hope this helps,

Christophe

-------------- next part --------------
A non-text attachment was scrubbed...
Name: model.geo
Type: application/octet-stream
Size: 457 bytes
Desc: not available
URL: <http://www.geuz.org/pipermail/gmsh/attachments/20130313/d0c67a73/attachment.geo>
-------------- next part --------------


On 19 Feb 2013, at 17:22, Mario Ceresa <mario.ceresa at alma3d.com> wrote:

> Hello everybody,
> first of all, thanks for gmsh: it is a really cool software!
> 
> I have an STL model which I would like to use with Elmer solver
> (http://www.csc.fi/english/pages/elmer)
> 
> In order to do so I need a volume mesh and the 6 enclosing surfaces
> for the BC conditions.
> 
> I read the manual and the page on STL remeshing
> (https://geuz.org/trac/gmsh/wiki/STLRemeshing) and I was able to
> obtain a volume mesh from it (see attached simple.zip). However, I'm
> unable to obtain also the 6 surfaces as separate entities (see
> surf.zip).
> 
> Is this possible with the current version of gmsh (gmsh 2.6.1)?
> 
> Thanks and regards,
> 
> Mario
> 
> --
> Mario Ceresa, PhD, Ing
> Senior Researcher at Alma IT System
> Vilana 4B, 4º 1ª - 08022 Barcelona, Spain
> T. +34 932.380592
> <simple.zip><surf.zip>_______________________________________________
> gmsh mailing list
> gmsh at geuz.org
> http://www.geuz.org/mailman/listinfo/gmsh

-- 
Prof. Christophe Geuzaine
University of Liege, Electrical Engineering and Computer Science 
http://www.montefiore.ulg.ac.be/~geuzaine