[Gmsh] Mesh Size Question

[John Assael]

I have a mesh where the Wire surface should be 1.606793E+09 m and the whole
Surface (wire+fluid) should have a radius of 12.915E-06m am I doing
something wrong? because I dont get the expected results? PS. the cellsize
should decrease the more far it is from 0,0 thanks!

cellSize = 1E-07;
cellSize2 = 5E-7;
cellSize3 = 1E-5;
cellSize4 = 1E-4;
radius = 12.915E-06;
fluidradius = 5E-04;

Point(1) = {0, 0, 0, cellSize};
Point(2) = {radius, 0, 0, cellSize};
Point(3) = {0, radius, 0, cellSize};
Point(4) = {fluidradius, 0, 0, cellSize4};
Point(5) = {0, fluidradius, 0, cellSize4};

Point(6) = {fluidradius*0.33, 0, 0, cellSize2};
Point(7) = {0, fluidradius*0.33, 0, cellSize2};
Point(8) = {fluidradius*0.66, 0, 0, cellSize3};
Point(9) = {0, fluidradius*0.66, 0, cellSize3};
Circle(1) = {3, 1, 2};
Line(2) = {1, 2};
Line(3) = {1, 3};
Line(4) = {2, 4};
Line(5) = {3, 5};
Circle(6) = {5, 1, 4};
Line Loop(8) = {1, -2, 3};
Plane Surface(8) = {8};
Line Loop(10) = {4, -6, -5, 1};
Plane Surface(10) = {10};
Physical Surface("Wire") = {8};
Physical Surface("Fluid") = {10}


-- 
..:: ic3man.gr ::..
software | design | development
_/_/_/ email: iassael at gmail.com
_/_/_/ www : http://www.ic3man.gr
------------------------------------------------------------------
This e-mail and any attachments are confidential. You may not copy
or disseminate any information  contained in them  to anyone other
than the intended recipient. If you are not the intended recipient
please contact the sender by reply  e-mail and destroy all  copies
of the original message immediately.
------------------------------------------------------------------
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://www.geuz.org/pipermail/gmsh/attachments/20130120/006144fc/attachment.html>