[Gmsh] Fwd: R: Re: From points to surface

[David Colignon]

-------- Original Message --------
Subject: R: Re: [Gmsh] From points to surface
Date: Tue, 25 Oct 2011 13:34:57 +0200 (CEST)
From: isettagi at libero.it <isettagi at libero.it>
Reply-To: isettagi at libero.it <isettagi at libero.it>
To: <David.Colignon at ulg.ac.be>

This is good.
The Plugin to work asks me a mesh. I did a ruled surface with the boundary
points and I meshed it. After that I run the pluging and create a new view.
Now I want to create a volume with this new view. But I am not able to save
the new view as surface.
How can I do?
Thank you very much

Isabella


>----Messaggio originale----
>Da: David.Colignon at ulg.ac.be
>Data: 23/10/2011 17.57
>A: "isettagi at libero.it"<isettagi at libero.it>
>Cc: <gmsh at geuz.org>
>Ogg: Re: [Gmsh] From points to surface
>
>Hi,
>
>see:  http://geuz.org/gmsh/doc/texinfo/gmsh.html#Post_002dprocessing-plugins
>
>
>Plugin(Triangulate)
>     Plugin(Triangulate) triangulates the points in the view `View', assuming
that all the points belong to a surface
>that can be projected one-to-one onto a plane.
>
>     If `View' < 0, the plugin is run on the current view.
>
>     Plugin(Triangulate) creates one new view. Numeric options:
>
>     View
>         Default value: -1
>
>
>Regards,
>
>Dave
>
>--
>David Colignon, Ph.D.
>Collaborateur Logistique du F.R.S.-FNRS
>CÉCI - Consortium des Équipements de Calcul Intensif
>ACE - Applied & Computational Electromagnetics
>Institut Montefiore B28
>Université de Liège
>4000 Liège - BELGIQUE
>Tél: +32 (0)4 366 37 32
>Fax: +32 (0)4 366 29 10
>WWW:    http://www.ceci-hpc.be/
>Agenda: http://www.google.com/calendar/embed?src=david.colignon%40gmail.com
>
>On 23/10/11 12:14, isettagi at libero.it wrote:
>>
>> Dear all!
>> I want to create a surface directly from points. Is it possible to do?how?
>> I have a DTM of an area, I want to trasform the points in xyz and import it
in
>> GMSH. I cannot create lines and areas for every nearest points, because it
is
>> too long. I'd like to create a surface directly from the points.
>> Can you help me?
>> Thank you very much for any suggestion.
>>
>> Isabella
>>
>> _______________________________________________
>> gmsh mailing list
>> gmsh at geuz.org
>> http://www.geuz.org/mailman/listinfo/gmsh
>
>