[Gmsh] Body of revolution with BSplines

[PL]

Hi Julien,

thanks for your help, you are right. Now all works!

Best regards,
Patrick

On 06/05/2011 11:42 AM, julien hoessler wrote:
> Hi Patrick,
> You get a lot of errors when meshing your test02. Could it be because
> you are using a single BSpline? The surface of revolution would be a
> curved surface based on only two edges when 3 at least are needed if I'm
> not mistaken. Attached is a modified version of your test02 with the
> BSpline split into two that works fine
> Regards
> Julien
>