[Gmsh] Meshing of compound volumes

Serban.Georgescu at uk.fujitsu.com Serban.Georgescu at uk.fujitsu.com
Fri Jun 10 10:42:54 CEST 2011


Dear Matthias,

Thank you for your quick reply.
Meshing worked fine after selecting the option you specified. However, when I tried the same thing with a more complex problem (e.g., lots of curved surfaces), I got the following error while opening the STEP file:

Error: TopOpenBRepBuild Builder::splitON

then I got again intersecting surfaces errors while meshing. Could the curved boundaries be the cause?

Thanks,
Serban

From: Zenker, Dr. Matthias [mailto:Dr.Matthias.Zenker at erbe-med.com]
Sent: 09 June 2011 11:42
To: Serban Georgescu; gmsh at geuz.org
Subject: AW: [Gmsh] Meshing of compound volumes

Hi,

you can try Options->Geometry->General->"Cut and merge faces" before meshing. This should work for duplicated planar faces.
A more general solution is being worked on (by me, actually...).

HTH,

Matthias

________________________________
Von: Serban.Georgescu at uk.fujitsu.com [mailto:Serban.Georgescu at uk.fujitsu.com]
Gesendet: Mittwoch, 8. Juni 2011 18:26
An: gmsh at geuz.org
Betreff: [Gmsh] Meshing of compound volumes
Hi all,

I have  quick question regarding the meshing of compound volumes.
I have a simple geometry, basically two cubes stacked together and sharing one face. If I fuse the blocks, then there is only one volume and meshing works correctly. However, if I export as a compound volume, so two volumes sharing one face, Gmsh gives loads of errors. Is there a way to mesh such compounds in Gmsh?

Thanks for your time,
Serban


______________________________________________________________________



 Fujitsu Laboratories of Europe Limited

 Hayes Park Central, Hayes End Road, Hayes, Middlesex, UB4 8FE

 Registered No. 4153469



 This e-mail and any attachments are for the sole use of addressee(s) and

 may contain information which is privileged and confidential. Unauthorised

 use or copying for disclosure is strictly prohibited. The fact that this

 e-mail has been scanned by Trendmicro Interscan does not guarantee that

 it has not been intercepted or amended nor that it is virus-free.



______________________________________________________________________
                                        
 Fujitsu Laboratories of Europe Limited
 Hayes Park Central, Hayes End Road, Hayes, Middlesex, UB4 8FE
 Registered No. 4153469
 
 This e-mail and any attachments are for the sole use of addressee(s) and
 may contain information which is privileged and confidential. Unauthorised
 use or copying for disclosure is strictly prohibited. The fact that this
 e-mail has been scanned by Trendmicro Interscan does not guarantee that 
 it has not been intercepted or amended nor that it is virus-free.
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://www.geuz.org/pipermail/gmsh/attachments/20110610/9c8e2c76/attachment.html>