[Gmsh] Mesh STEP file

Zenker, Dr. Matthias Matthias.Zenker at erbe-med.com
Tue Mar 29 13:47:21 CEST 2011


Hi Marc,
 
when I mesh your geometry (without defining physical groups) and open it with Elmerfem (www.csc.fi/elmer), I can see all surfaces as boundaries. So they must be in the msh file. The problem may be the way your cfd software reads the msh file.
 
HTH,
 
Matthias
 

---------------------------------------------------------------- 
ERBE Elektromedizin GmbH 
Dr.rer.nat. Matthias Zenker 
Dipl. Phys. 
Grundlagenentwicklung / Fundamental Development 
Waldhoernlestrasse 17 
72072 Tuebingen 
Germany 
Phone + 49 (0) 7071 755 - 226 
Fax + 49 (0) 7071 755 - 5226 
E-Mail: <mailto:Matthias.Zenker at erbe-med.com> 
URL: http://www.ERBE-med.com <http://www.erbe-med.com/>  
---------------------------------------------------------------- 

 

________________________________

Von: Marc Secca [mailto:mksca220 at yahoo.fr] 
Gesendet: Dienstag, 29. März 2011 12:57
An: gmsh at geuz.org
Betreff: [Gmsh] Mesh STEP file


Hello!
 
I am trying to mesh the attached STEP file in gmsh 2.4.2 and define boundaries for a cfd solver.  I can merge the file and select the relevant surfaces and volume as physical groups but after I mesh to geometry, I open the .msh file created and cannot see the boundaries I defined.  I tried saving the geometry as a .geo file but surfaces are missing at the pipe intersections.
 
Is there a better way to do this? Can I repair the missing surfaces?
 
Thanks for any help you can provide.
 
Marc
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://www.geuz.org/pipermail/gmsh/attachments/20110329/51dba300/attachment.html>