[Gmsh] GMSH

[Christophe Geuzaine]

On 21/01/11 18:49, claudio wrote:
> Dear Sirs,
>
> my name is Claudio Comis and I am a PhD candidate at the University of
> Padua in Energetics.
> With the present mail, I kindly ask You if You can indicate to me a
> tutorial regarding the boundary layer building (a 3D case) in GMSH
> environment.
> The .geo file would be very helpful, too.

Hi Claudio - the current code for building boundary layers is still 
quite unrefined (it only works in 3D, and does not try to solve any of 
the "hard" problems, e.g. for handling sharp corners or edges).

To test it just use the standard Extrude command and omit the 
translation/rotation arguments altogether. Attached are two small examples.

>
>
> Yours sincerely,
>
> Claudio Comis
> --
> Ing. Claudio Comis Da Ronco
> University of Padova
> Department of Mechanical Engineering
> Via Venezia, 1 - 35131 Padova, Italy
> Phone  3494552408
> claudio.comis at unipd.it
> claudio.comis at alice.it
>
>
>
> _______________________________________________
> gmsh mailing list
> gmsh at geuz.org
> http://www.geuz.org/mailman/listinfo/gmsh
>


-- 
Prof. Christophe Geuzaine
University of Liege, Electrical Engineering and Computer Science
http://www.montefiore.ulg.ac.be/~geuzaine
-------------- next part --------------
An embedded and charset-unspecified text was scrubbed...
Name: sphere_boundary_layer.geo
URL: <http://www.geuz.org/pipermail/gmsh/attachments/20110122/a23d6d5c/attachment.geo>
-------------- next part --------------
An embedded and charset-unspecified text was scrubbed...
Name: t1_boundary_layer.geo
URL: <http://www.geuz.org/pipermail/gmsh/attachments/20110122/a23d6d5c/attachment-0001.geo>