[Gmsh] Question sur GMSH

[Mark van Doesburg]

	"Zenker, Dr. Matthias" <Matthias.Zenker at erbe-med.de> wrote:

	I have the same problem with geometries imported from 3D CAD, and
	so far the only way is to remove the duplicate surfaces manually,
	which is tedious.  There was a project to enable gmsh to detect
	duplicate surfaces and clean them up. Does anyone know if there
	has been any progress?	

Unfortunately trying to use OCC was a mistake. I intend to write something from
scratch, but that will only be able to work on straight lines and plane faces.

	Maybe it would be easier to detect the overlapping surfaces and
	force the mesh to be conformal?

That would be nice, and possible when I'm done. But it will take a lot
of time before I can start, and then even more time to finish it.

Mark van Doesburg.