[Gmsh] How to integrate GetDP-solver with Gmsh

[Tuomo Korpela]

Hi,

I have downloaded Gmsh-mesher and GetDP-solver.

I am trying to test a simple mechanical problem:
4000 mm long beam with 330x100 mm cross section and
98100 N point load in the middle, fixed ends.

I have put ´getdp.exe´ into same directory with Gmsh.

I am getting some errors and warnings:

Error: Socket listen timeout on ´127.0.0.1:44122´
Error: Is ´getdp.exe´ correctely installed?
Warning: No Resolution available.
Warning: No PostOperation available.
Warning: Invalid choice (-1) for option 0.

Pre, Cal and Pos editors are appearing only for one second time.

How to fix these problems and get GetDP-solver functioning?
How to place constraints and point loads in GetDP?

Best regards,

Tuomo Korpela
Helsinki
Finland




      __________________________________________________________
Går det långsamt? Skaffa dig en snabbare bredbandsuppkoppling. 
Sök och jämför priser hos Kelkoo.
http://www.kelkoo.se/c-100015813-bredband.html?partnerId=96914325