[Gmsh] About read *.step file function?

wing yongjin.liu at gmail.com
Wed Dec 31 13:36:30 CET 2008


liang dong wrote:
> hi wing
>  Once again, thank you  so much! sorry,I donot konw the mean" gmsh 
> your_file_name.step
>  ' ,I want to kown the fuction read *.step file .And the mesh modle 
> need which information come from *.step file ? Thanks you very much!
>                                                                                                             
> liang
> --- *08年12月27日,周六, wing /<yongjin.liu at gmail.com>/* 写道:
>
>     发件人: wing <yongjin.liu at gmail.com>
>     主题: Re: [Gmsh] About read *.step file function?
>     收件人: edongliang at yahoo.com
>     抄送: gmsh at geuz.org
>     日期: 2008,1227,周六,8:57上午
>
>     liang dong wrote:
>     > hi:
>     > I have problem about *.step file .I want to konw how to read *.step
>     > file in gmsh? Is "loadstep()" function? Can you tell me where
>     the
>     > function read the *step ?I cannot find it.
>     > Thank you very much!!
>     > dongliang
>     >
>     >
>     > ------------------------------------------------------------------------
>     > 好玩贺卡等你发,邮箱贺卡全新上线!
>     >
>     <http://cn.rd.yahoo.com/mail_cn/tagline/card/*http://card.mail.cn.yahoo.com/>
>     >
>     > ------------------------------------------------------------------------
>     >
>     > _______________________________________________
>     > gmsh mailing list
>     > gmsh at geuz.org
>     > http://www.geuz.org/mailman/listinfo/gmsh
>     >   
>     Hi dongliang,
>     I'm not sure if there exists a loadstep() function, but when it comes to
>     how to read *.step file in gmsh, you can try this:
>     gmsh your_file_name.step
>
>     hope this helps.
>
>     wing
>               
>
>
> ------------------------------------------------------------------------
> 好玩贺卡等你发,邮箱贺卡全新上线! 
> <http://cn.rd.yahoo.com/mail_cn/tagline/card/*http://card.mail.cn.yahoo.com/> 

Hi dongliang,
Seems that you are talking about the source code? I'm sorry I'm not 
familiar with programming, even the source code itself, but I believe 
somebody here can help if your question is described in more detail.
BTW, you should cc your mail to the mailing list <gmsh at geuz.org> so 
that  everyone in the list can receive  your message.  Use  "Reply to 
all" rather than  just  "Reply"  next  time.
Good luck.

wing