[Gmsh] lower limit for characteristic length

[Zenker, Dr. Matthias]

Hi,

I wonder if there is a lower limit for the characteristic length. I have
a rather simple 2D geometry, and if I set the cl for just two points to
0.0001, gmsh crashes during the meshing after having given the error
message "3 identical points in Qtest". The .gmsh-errors file is not
written. With cl=0.0005, this does not happen (but it takes veeery long
to compute the mesh).

Best regards,

Matthias

----------------------------------------------------------------
ERBE Elektromedizin GmbH
Dr.rer.nat. Matthias Zenker
Dipl. Phys.
Grundlagenentwicklung Technologie
Waldhoernlestrasse 17
D-72072 Tuebingen
Tel.: + 49 (0) 7071 - 755 226
Fax: + 49 (0) 7071 - 755 5226
E-Mail: <mailto:Matthias.Zenker at ERBE-med.de>
URL: http://www.ERBE-med.de
----------------------------------------------------------------


_____________________________________________________________________
ERBE Elektromedizin GmbH
Firmensitz: 72072 Tuebingen
Geschaeftsfuehrer: Christian O. Erbe, Reiner Thede
Registergericht: Stuttgart HRB 380137

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://www.geuz.org/pipermail/gmsh/attachments/20081117/0a969ee7/attachment.html>