[Gmsh] Gmsh 2.2.5 crashes on use of 2nd order elements (no optimization)

[Roland Tollenaar]

Hi All,

Thanks for pointing our that my earlier model had only lines and points. 
I reverted to that because the same model with surfaces does mesh, but 
crashes ruthlessly if I apply 2nd order elements.

This is new, I used to be able to mesh a similar model with 2nd order 
elements as long as I did not apply the netgen optimizer.

Can someone comment on this? Attached is the model.

Kind regards,

Roland


Ruth V. Sabariego wrote:
> Your model seems to have only lines and points, that's why you don't see 
> a 2D/3D mesh.
> The 1D mesh is done correctly.
> 
> Ruth
> 
> Roland Tollenaar wrote:
>> Hello,
>>
>> I have a model which fails to mesh. gmsh says its meshing it (console) 
>> but nothing happens. (0s)
>>
>> I have seen this same behaviour with STL models previously and simply 
>> assumed that gmsh could not handle stl files.
>>
>> However this is a step model of a type that gmsh previously did mesh 
>> well.
>>
>> I have attached the model.
>>
>> Kind regards,
>>
>> Roland
>> ------------------------------------------------------------------------
>>
>> _______________________________________________
>> gmsh mailing list
>> gmsh at geuz.org
>> http://www.geuz.org/mailman/listinfo/gmsh
> 
> -- 
> Dr. Ir. Ruth V. Sabariego
> University of Liege, Institut Montefiore,
> Dept. of Electrical Engineering & Computer Science, 
> Applied & Computational Electromagnetics (ACE),
> Sart Tilman Campus, Grande Traverse, 10 (B28), B-4000 LIEGE, Belgium
> phone: +32-4-3663737 -- fax: +32-4-3662910 -- http://elap.montefiore.ulg.ac.be/
> 
-------------- next part --------------
An embedded and charset-unspecified text was scrubbed...
Name: ASSEMBLY CASSETE_04.STEP
URL: <http://www.geuz.org/pipermail/gmsh/attachments/20081117/50c47a68/attachment.STEP>