[Gmsh] mesh generation

Stefano Zinna stefano.zinna at uniheat.it
Thu Nov 13 18:27:22 CET 2008


Hello.

I imported and meshed by 2.2.5 but i see just faces and no volume 
inside. Can you explain which steps you made?

thanks,
Stefano


Ruth V. Sabariego ha scritto:
> Hi,
>
> I've just meshed you model in 3D using the nightly-build gmsh version 
> (2.2.5). The volume is detected and meshed.
>
> Regards,
> Ruth
>
> Stefano Zinna wrote:
>> Hello.
>>
>> This is the step file of the section i have sent. Let me know if it 
>> is what you need. thanks.
>>
>> regards.
>> Stefano
>>
>>
>>
>> Ruth V. Sabariego ha scritto:
>>> Could you send just the section of TOLOMEO LED you used to generate 
>>> the mesh?
>>> If in the imported file there are only surfaces, you should add a 
>>> surface loop to consider the volume and be able to mesh it.
>>>
>>> Regards,
>>> Ruth
>>>
>>> Stefano Zinna wrote:
>>>> Dear Sirs.
>>>>
>>>> I have a problem when crossing from surface mesh to volume mesh in 
>>>> Gmsh.
>>>> I'm using Gmsh 2.2.4 version. It seems that Gmsh is not able to 
>>>> recognize volumes in the surface mesh attached (56.stl.tar.gz). 
>>>> Also i attach the starting CAD file (TOLOMEO LED.stp.tar.gz) where 
>>>> i took a section to create the surface mesh.
>>>> Let me know if you can help me. Many thanks
>>>>
>>>> best regards,
>>>> Stefano Zinna
>>>> ------------------------------------------------------------------------ 
>>>>
>>>>
>>>> _______________________________________________
>>>> gmsh mailing list
>>>> gmsh at geuz.org
>>>> http://www.geuz.org/mailman/listinfo/gmsh
>>>
>>> -- 
>>> Dr. Ir. Ruth V. Sabariego
>>> University of Liege, Institut Montefiore,
>>> Dept. of Electrical Engineering & Computer Science, Applied & 
>>> Computational Electromagnetics (ACE),
>>> Sart Tilman Campus, Grande Traverse, 10 (B28), B-4000 LIEGE, Belgium
>>> phone: +32-4-3663737 -- fax: +32-4-3662910 -- 
>>> http://elap.montefiore.ulg.ac.be/
>>
>