[Gmsh] DFX or DWG file conversor

[Ruth V. Sabariego]

No, it does not.
You could convert your files to e.g. iges or step to use Gmsh.

Ruth


Carlos Henrique da Silva Santos wrote:
> Dear Colleagues!
>  
>    Has an interpreter of the DXF or DWG files in the gmsh? (For 3D 
> strucutures) 
>  
> Best Regards!!
>  
> -- 
> ==================================================
> Carlos Henrique da Silva Santos, M.Sc.
> Ph.D. Degree Student - CePOF Collaborator
> Laboratory of Electromagnetism Applied and Computational (LEMAC)
> Department of Microwaves and Optics (DMO)
> School of Electrical and Computer Engineer (FEEC)
> State University of Campinas (UNICAMP)
> Phone: +55(19)3521-5175
> ==================================================
> ------------------------------------------------------------------------
>
> _______________________________________________
> gmsh mailing list
> gmsh at geuz.org
> http://www.geuz.org/mailman/listinfo/gmsh
>   


-- 
Dr. Ir. Ruth V. Sabariego
University of Liege
Dept. of Electrical Engineering (ELAP), Institut Montefiore
Sart Tilman Campus, Grande Traverse, 10 (B28), B-4000 LIEGE, Belgium
phone: +32-4-3663737 -- fax: +32-4-3662910 -- http://elap.montefiore.ulg.ac.be/

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://www.geuz.org/pipermail/gmsh/attachments/20070328/894b2ebb/attachment.html>