[Gmsh] recombine into all quads

[Christophe Geuzaine]

Marc Secanell wrote:
> Hi all,
> 
> I wanted to use GMSH to create quadrilateral meshes. In the past, you 
> had an algorithm to recombine triangular meshes into All Quads, however, 
> I've noticed that this option is not active anymore in the GMSH GUI. Is 
> there a reason for such change? Also, is this a permanent change and All 
> Quad meshes will not be supported anymore?


Hi Marc - It's one of the things we need to recode in the new version.
It should be back in 2.1.



> 
> Thank you,
> 
> Marc
> 
> ------------------------------------------------------------------------------------------------
> 
> Marc Secanell Gallart, MASc
> 
> PhD Candidate
> 
> Institute for Integrated Energy Systems (IESVic)
> 
> Department of Mechanical Engineering, University of Victoria, Canada
> 
> Phone:          (250) 721 8662
> 
> Fax:               (250) 721-6051
> 
> e-mail:           secanell at uvic.ca <mailto:secanell at uvic.ca>
> 
> homepage:  www.me.uvic.ca/~msecanel
> 
> --------------------------------------------------------------------------------------------------
> 
> 
> 
> ------------------------------------------------------------------------
> 
> _______________________________________________
> gmsh mailing list
> gmsh at geuz.org
> http://www.geuz.org/mailman/listinfo/gmsh


-- 
Prof. Christophe Geuzaine
University of Liege, Electrical Engineering and Computer Science
http://www.montefiore.ulg.ac.be/~geuzaine