[Gmsh] hi, a question

Christophe Geuzaine geuzaine at acm.caltech.edu
Fri Nov 26 23:30:40 CET 2004


miguel montoya wrote:
> I am working simulating a piece. The piece consist of
> a part massive and a pipe. I want to generate a pipe
> hollow initiating in a hole and finishing in the
> other. When I generate the pipe and I do the mesh one
> appears the coplanar problem......
> 
> Send the archives corresponding to the same piece all
> massive one.
> 
> diameter outside = 12,7mm
> diameter inside = 10,92mm
> 
> 
> Geometria is conserved equal, so single I want the
> tubes of hollow section.
> 

Could you send the file that doesn't work?

C.

> been thankful
> 
> Miguel Montoya Vallejo
> Mechanical Engineer
> 
> __________________________________________________
> Do You Yahoo!?
> Tired of spam?  Yahoo! Mail has the best spam protection around 
> http://mail.yahoo.com 
> 
> 
> ------------------------------------------------------------------------
> 
> _______________________________________________
> gmsh mailing list
> gmsh at geuz.org
> http://www.geuz.org/mailman/listinfo/gmsh


-- 
Christophe Geuzaine
Applied and Computational Mathematics, Caltech
geuzaine at acm.caltech.edu - http://geuz.org