run getdp backstage

[Christophe Geuzaine]

Lin Ji wrote:
> 
> Hi, Christophe,
>     I tried to run getdp backstage. It works fine and output the results to
> 'test.res'. However, there is a little problem redirecting the screen output
> to a file. I used '>' to redirect the screen output of processing info to a
> file as follows
> 
> /personal/research/proj_rep/wave2D (11) ../../getdp-0.821/getdp test -pre
> 'Wave_t_ex' -cal -pos 'u' > output &

You also have to redirect the error stream, i.e.

... >& output &

Note that it may be simpler to use the '-log' option, together with a
low verbosity mode (e.g. '-v 0').

> 
> But, the output info still goes to the terminal and in the end the
> postprocessing did not write the file 'u.pos' as it is supposed to.

That's not normal. If you're sure about this (check your post-operation
definitions), send me your files.

Christophe

-- 
Christophe Geuzaine

Tel: 32 (0) 4 366 37 10    http://geuz.org
Fax: 32 (0) 4 366 29 10    mailto:Christophe.Geuzaine at ulg.ac.be